If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Always On the Look Out for Troy Percival & Randy Johnson Gamers
Rob L's Baseball Memorabilia website: GU Troy Percival, GU Randy Johnson, GU Angels, GU Baseball, 19th Century Baseball and Autographs. Also a huge Game Used Resource page and Game Used Collectors Page: www.loefflerrd.webs.com
I do all of my own repairs - and have been getting better over time.
I use strong wood glue and 'trigger' vice grips that have thick rubber pads on them. I'll try to get some photos up later. Using ultra-fine sandpaper on a blonde unfinished bat can make the crack almost invisible if the repair is done well. I just make sure to use plenty of glue and as much pressure as possible with the grips (at least 2).
My best success at gluing and clamping bad break is: lotsa wood glue, then wrap in Saran Wrap, then use hose clamps (hex head screw type) lined with rubber or leather. Put the clamps about 1" or less and used the appropriate graded sizes. Hoses clamps insure you'll keep it in round.
Use plastic wood for filling missing pieces.
I only repair the bats that are in two or more pieces. And sometimes will touch up with pine tar if by repairing the area some was removed. Black bats are the easiest. I won't touch anything that isn't ready to fall apart.
The first bat I did was in 5 pieces and when I finished it, it looked like it was right from the factory. After applying pinetar and slapping some rosin on it it was great. Much better than a 5-piece bat but I always mark them with a "repaired" tag.
Comment